Improper maintenance of the selected faucet can affect its service life, which is a headache for many people. The frequency of use of faucets is high, and they are used every day. Under such high frequency of use, how can the faucet be maintained to increase its service life? In fact, this is not a difficult task. Below, we will teach you how to install, use, and maintain faucets correctly. The actual service life of faucets can not only be extended, but also maintained as bright as new.

1. When the gas temperature is below 0 degrees, if abnormal hand feel is found on the faucet handle, it must be scalded with hot water until the hand feel is normal before use. Otherwise, it will affect the service life of the faucet valve core.

2. After the faucet is closed, there will be dripping water, which is a normal phenomenon caused by the residual water in the faucet cavity of the Kaiping faucet. If the product continues to drip for more than ten minutes over a long period of time, it is considered to be leaking, indicating a quality issue with the product.

3. Due to the presence of trace amounts of carbonic acid in water, the formation of scale on the metal surface after evaporation can corrode the surface of the faucet, affecting its cleanliness and service life. So after using the faucet, it is necessary to frequently use a soft cotton or sponge cloth and neutral soap water to scrub the surface of the faucet (note: do not use corrosive or acidic substances to scrub), and then dry the surface with a soft cloth. Avoid using metal wire balls or scouring pads with hard particles.

4. Do not use too much force to turn on and off the faucet, gently roll it along with the flow. Even traditional faucets do not require a lot of force to turn. Especially do not use the handle as a armrest to support or apply. It is not advisable for many people to intentionally turn off the faucet after use. Not only does it fail to prevent water leakage, but it can also damage the sealing valve and cause the faucet to not close tightly.

5. When the water flow decreases, impurities should be removed. When the water pressure is not less than 0.02 MPa, if a decrease in water output is found, it may be due to blockage inside the faucet. The solution is to gently unscrew the water nozzle screen cover at the outlet of the faucet with a wrench, clean the impurities, and then carefully install it. Generally, it can be restored to its original state.